Abstract
Cellulolytic enzyme lignin (CEL) and milled wood lignin (MWL) were prepared by three different ball-milling methods. The structure of CEL at various yields was elucidated and compared with MWL using wet chemical analysis, FTIR and solution-state NMR techniques. Results show that ball milling of wood degrades β-O-4 structures in lignin. However, even after extensive ball milling, less than 25% of the β-O-4 structures were degraded. The extent of degradation was less for softwood than for hardwood lignin. Extractable lignin yield, either MWL or CEL, was the best way to assess the extent and effect of ball milling. CEL is preferred over MWL, as it can be isolated in higher yield with less degradation. CEL was isolated at yields ranging from 20% to 86%. Over this range the CEL had similar structures, suggesting that lignin in the secondary wall is uniform in structure. The residual enzyme lignin (REL) was structurally different from CEL and may originate mainly from the middle lamella. In this paper we propose a new procedure for the isolation of lignin for use in structural studies, whereby wood is sufficiently milled and successively extracted to produce three lignin fractions representing the total lignin in wood.
References
Adler, E. (1977) Lignin chemistry – past, present and future. Wood Sci. Technol.11:169–218.10.1007/BF00365615Search in Google Scholar
Akiyama, T., Sugimoto, T., Matsumoto, Y., Meshitsuka, G. (2002) Erythro/threo ratio of β-O-4 structures as an important structural characteristic of lignin. I: Improvement of ozonation method for the quantitative analysis of lignin side-chain structure. J. Wood Sci.48:210–215.Search in Google Scholar
Balakshin, M.Y., Capanema, E.A., Chang, H.-m. (2006) A fraction of MWL with high concentration of lignin-carbohydrate linkages: Isolation and analysis with 2D NMR spectroscopic techniques. Holzforschung, submitted for publication.10.1515/HF.2007.001Search in Google Scholar
Björkman, A. (1954) Isolation of lignin from finely divided wood with neutral solvents. Nature174:1057–1058.10.1038/1741057a0Search in Google Scholar
Blakeney, A.B., Harris, P.J., Henry, R.J., Stone, B.A. (1983) A simple and rapid preparation of alditol acetates for monosaccharide analysis. Carbohydr. Res.113:291–299.10.1016/0008-6215(83)88244-5Search in Google Scholar
Boerjan, W., Ralph, J., Baucher, M. (2003) Lignin biosynthesis. Annu. Rev. Plant Biol.54:519–546.10.1146/annurev.arplant.54.031902.134938Search in Google Scholar PubMed
Capanema, E.A., Balakshin, M.Y., Kadla, J.F. (2004) A comprehensive approach for quantitative lignin characterization by NMR spectroscopy. J. Agric. Food Chem.52:1850–1860.10.1021/jf035282bSearch in Google Scholar PubMed
Capanema, E.A., Balakshin, M.Y., Heerman, M.L., Yeh, T.-F., Yu, Q., Nelson, C.D., Mckeand, S.E., Li, B., Jameel, H., Chang, H.-m., Mullin, T.J. (2005) Chemical properties in CAD-deficient pine and their effect on pulping. In: Proceedings of the 13th ISWPC, Auckland, New Zealand.Search in Google Scholar
Chang, H.M., Cowling, E.B., Brown, W., Adler, E., Miksche, G. (1975) Comparative studies on cellulolytic enzyme lignin and milled wood lignin of sweetgum and spruce. Holzforschung29:153–159.10.1515/hfsg.1975.29.5.153Search in Google Scholar
Dence, C.W. Methods in Lignin Chemistry. Springer-Verlag, Berlin, 1992.Search in Google Scholar
Fujimoto, A., Matsumoto, Y., Meshitsuka, G., Chang, H.M. (2004) Effects of milling conditions on the structure of MWL. In: Proceedings of the 2nd International Symposium on Technologies of Pulping, Papermaking and Biotechnology of Fiber Plants, Nanjing, China, October 13, 2004. pp. 144–146.Search in Google Scholar
Fujimoto, A., Matsumoto, Y., Chang, H.M., Meshitsuka, G. (2005) Quantitative evaluation of milling effects on lignin structure during the isolation process of milled wood lignin. J. Wood Sci.51:89–91.10.1007/s10086-004-0682-7Search in Google Scholar
Fukushima, K., Terashima, N. (1991) Heterogeneity in formation of lignin XIV. Formation and structure of lignin in different xylem of Ginkgo biloba. Holzforschung45:413–433.Search in Google Scholar
Gellerstedt, G., Northey, R.A. (1989) Analysis of birch wood lignin by oxidative degradation. Wood Sci. Technol.23:75–83.10.1007/BF00350609Search in Google Scholar
Holtman, K., Chang, H.M., Jameel, H., Kadla, J.F. (2003) Elucidation of lignin structure through degradative methods: comparison of modified DFRC and thioacidolysis. J. Agric. Food Chem.51:3535–3540.10.1021/jf0340411Search in Google Scholar PubMed
Holtman, K.M., Chang, H.M., Kadla, J.F. (2004) Solution-state nuclear magnetic resonance study of the similarities between milled wood lignin and cellulolytic enzyme lignin. J. Agric. Food Chem.52:720–726.10.1021/jf035084kSearch in Google Scholar PubMed
Ikeda, T., Holtman, K., Kadla, J.F., Chang, H.M., Jameel, H. (2002) Studies on the effect of ball milling on lignin structure using a modified DFRC method. J. Agric. Food Chem.50:129–135.10.1021/jf010870fSearch in Google Scholar PubMed
Lai, Y.Z., Sarkanen, K.V. (1971) Isolation and structural studies. In: Lignins: Occurrence, Formation, Structure and Reactions. Eds. Sarkanen, K.V.L., Ludwig, C.H. Wiley-Interscience, New York. pp. 165–230.Search in Google Scholar
Lundquist, K., Simonson, R.,Tingsvik, K. (1980) Studies on lignin carbohydrate linkages in milled wood lignin preparations. Svensk Papperstidn.83:452–454.Search in Google Scholar
Matsumoto, Y., Ishizu, A., Nakano, J. (1986) Studies on chemical structure of lignin by ozonation. Holzforschung40:81–85.Search in Google Scholar
Onnerud, H., Gellerstedt, G. (2003) Inhomogeneities in the chemical structure of spruce lignin. Holzforschung57:165–170.10.1515/HF.2003.025Search in Google Scholar
Pew, J.C. (1957) Properties of powered wood and isolation of lignin by cellulytic enzymes. Tappi40:553–558.Search in Google Scholar
Ralph, J., Lundquist, K., Brunow, G., Lu, F., Kim, H., Schatz, P.F., Marita, J.M., Hatfield, R.D., Ralph, S.A., Christensen, J.H., Boerjan, W. (2004) Lignins: natural polymers from oxidative coupling of 4-hydroxyphenylpropanoids. Phytochem. Rev.3:29–60.10.1023/B:PHYT.0000047809.65444.a4Search in Google Scholar
Scott, J.A., Procter, R.A., Fergus, B.J., Goring, D.A.I. (1969) The application of ultraviolet microscopy to the distribution of lignin in wood. Description and validity of the technique. Wood Sci. Technol.3:73–92.Search in Google Scholar
Terashima, K., Fukushima, K. (1988) Heterogeneity in formation of lignin XI. An autoradiographic study of the heterogeneous formation and structure of pine lignin. Wood Sci. Technol.22:259–270.Search in Google Scholar
Whiting, P., Goring, D.A.I. (1982) Chemical characterization of tissue fractions from the middle lamella and secondary wall of black spruce tracheids. Wood Sci. Technol.16:261–267.10.1007/BF00353149Search in Google Scholar
Yang, J.-M., Goring, D.A.I. (1980) The phenolic hydroxyl content of the lignin in spruce wood. Can. J. Chem.16:2411–2414.10.1139/v80-389Search in Google Scholar
Yokoyama, T., Kadla, J.F., Chang, H.M. (2002) Microanalytical method for the characterization of fiber components and morphology of woody plants. J. Agric. Food Chem.50:1040–1044.10.1021/jf011173qSearch in Google Scholar PubMed
Zakis, G.G. Functional analysis of lignins and their derivatives. TAPPI Press, Atlanta, GA, 1994.Search in Google Scholar
©2006 by Walter de Gruyter Berlin New York