Abstract
The main objective of this study was to test a new sensor based on the temperature drop across the load (TDAL). The TDAL sensor was designed to determine the transition point between wet and dry wood without any specific information about the drying process. When additional information is available, the TDAL sensor can also be used to monitor drying rate and estimate the drying end-point. In this study, three potential applications of TDAL sensor for lumber drying were explored, namely, to monitor drying rate, to detect the transition point between wet and dry wood, and for determination of drying end-point after calibration. For the first application, it was demonstrated that the transition point between wet and dry wood coincides with the time at which the TDAL decreases with time at a constant logarithmic slope. For the second application, the TDAL sensor was calibrated with nine experimental drying runs, and the end-points determined with the calibrated TDAL sensor did not show a significant difference with the end-points determined by the in-kiln MC meter. Finally, the TDAL sensor was used to monitor drying rate during drying.
©2009 by Walter de Gruyter Berlin New York