Skip to content
Licensed Unlicensed Requires Authentication Published by De Gruyter January 1, 2005

Cellulose microfibrils: A novel method of preparation using high shear refining and cryocrushing

Ayan Chakraborty, Mohini Sain and Mark Kortschot
From the journal

Abstract

This paper describes a novel technique to produce cellulose microfibrils through mechanical methods. The technique involved a combination of severe shearing in a refiner, followed by high-impact crushing under liquid nitrogen. Fibers treated in this way were subsequently either freeze-dried or suspended in water. The fibers were characterized using SEM, TEM, AFM, and high-resolution optical microscopy. In the freeze-dried batch, 75% of the fibrils had diameters of 1 μm and below, whereas in the water dispersed batch, 89% of the fibrils had diameters in this range. The aspect ratio of the microfibrils ranged between 15 and 55 for the freeze-dried fibrils, and from 20 to 85 for the fibrils dispersed in water. These measurements suggest that the microfibrils have the potential to produce composites with high strength and stiffness for high-performance applications. The microfibrils in water were compounded with polylactic acid polymer to form a biocomposite. Laser confocal microscopy showed that the microfibrils were well dispersed in the polymer matrix.

:

Corresponding author. Department of Chemical Engineering and Applied Chemistry, Faculty of Forestry, University of Toronto, 33 Willcocks Street, Toronto ON M5S 3B3, Canada

References

Batitista, O.A. Microcrystal Polymer Science, McGraw Hill, 1975. p. 17.Search in Google Scholar

Brown, R.M., Jr., Willison, J.H.M., Richardson, C.L. (1976) Cellulose biosynthesis in Acetobacter xylinum: Visualization of the site of synthesis and direct measurement of the in vivo process. Proc. Natl. Acad. Sci. USA73:4565–4569.10.1073/pnas.73.12.4565Search in Google Scholar

Crawshaw, J., Cameron, R.E. (2000) A small angle X-ray scattering study of pore structure in Tencel cellulose fibres and the effects of physical treatments. Polymer41:4691–4698.10.1016/S0032-3861(99)00502-9Search in Google Scholar

Dinand, E., Chanzy, H., Vignon, M.R. (1999) Suspensions of cellulose microfibrils from sugar beet pulp. Food Hydrocolloid.13:275–283.10.1016/S0268-005X(98)00084-8Search in Google Scholar

Dufresne, A., Cavaille, J.-Y., Vignon, M.R. (1997) Mechanical behavior of sheets prepared from sugar beet cellulose microfibrils. J. Appl. Polym. Sci.64 (6):1185–1194.10.1002/(SICI)1097-4628(19970509)64:6<1185::AID-APP19>3.0.CO;2-VSearch in Google Scholar

Dufresne, A., Dupeyre, D., Vignon, M.R. (2000) Cellulose microfibrils from potato tuber cells: Processing and characterization of starch-cellulose. J. Appl. Polym. Sci.76:2080–2092.10.1002/(SICI)1097-4628(20000628)76:14<2080::AID-APP12>3.0.CO;2-USearch in Google Scholar

Eichhorn, S.J., Young, R.J. (2001) The Young's modulus of a microcrystalline cellulose. Cellulose8:197–207.10.1023/A:1013181804540Search in Google Scholar

Grunert, M., Winter, W.T. (2002) Nanocomposites of cellulose acetate butyrate reinforced with cellulose nanocrystals. J Polym. Environ.10 (1/2):27–30.10.1023/A:1021065905986Search in Google Scholar

Günther, I. (1960) Elektronenmikroskopische Untersuchungen an der keimenden Spore von Funaria hygrometrica. J. Ultrastruct. Res.4:302–331.10.1016/S0022-5320(60)80025-1Search in Google Scholar

Herrick, F.W., Casebier, R.L., Hamilton, J.K., Sandberg, K.R. (1983) Microfibrillated cellulose: Morphology and accessibility. J. Appl. Polym. Sci.: Applied Polymer Symposium37:797–813.Search in Google Scholar

Heux, L., Dinand, E., Vignon, MR. (1999) Structural aspects in ultrthin cellulose microfibrils produced by 13C CP-MAS NMR. Carbohydrate Polymers40:115–124.10.1016/S0144-8617(99)00051-XSearch in Google Scholar

Hodge, A.J., Wardrop, A.B. (1950) An electron microscopic investigation on the cell wall organization of conifer tracheids. Nature165:272–275.10.1038/165272a0Search in Google Scholar

Kielty, C.M., Hanssen, E., Shuttleworth, C.A. (1998) Purification of fibrillin-containing microfibrils and collagen VI microfibrils by density gradient centrifugation. Anal. Biochem.255:108–112.10.1006/abio.1997.2442Search in Google Scholar

Preston, R.D. (1951) Fibrillar units in the structure of native cellulose. Faraday Soc. Disc.11:165–170.10.1039/df9511100165Search in Google Scholar

Qiu, W., Zhang, F., Endo, T., Hirotsu, T. (2003) Preparation and characterization of composites of high-crystalline cellulose with polypropylene: Effects of maleated polypropylene and cellulose content. J. Appl. Polym. Sci.87:337–345.10.1002/app.11446Search in Google Scholar

Rydholm, S.A. Pulping Processes. Interscience Publishers, 1965. p. 112.Search in Google Scholar

Sakurada, I., Nukushina, Y., Ito, T. (1962) Experimental determination of the elastic modulus of crystalline regions of oriented polymers. J. Polym. Sci.57:651–660.10.1002/pol.1962.1205716551Search in Google Scholar

Taniguchi, T. (1996) Microfibrillation of natural fibrous materials. J. Soc. Mat. Sci. Japan45 (4):472–473.Search in Google Scholar

Tokoh, C., Takabe, K., Fujita, M., Saiki, H. (1998) Cellulose synthesized by Acetobacter xylinum in the presence of acetyl glucomannan. Cellulose5:249–261.10.1023/A:1009211927183Search in Google Scholar

Turbak, A.F., Snyder, F.W., Sandberg, K.R. (1983) Microfibrillated cellulose, a new cellulose product: Properties, uses, and commercial potential. J. Appl. Polym. Sci.: Applied Polymer Symposium37:815–827.Search in Google Scholar

Vogel, A. (1953) Zur Feinstruktur von Ramie. Makromol. Chem.11:111–130.10.1002/macp.1953.020110113Search in Google Scholar

Yu, X., Atalla, R.H. (1998) A staining technique for evaluating the pore structure variations of micricrystalline cellulose powders. Powder Technol.98:135–138.10.1016/S0032-5910(98)00024-2Search in Google Scholar

Published Online: 2005-01-01
Published in Print: 2005-01-01

©2004 by Walter de Gruyter Berlin New York