Change language
English Deutsch
Change currency
€ EUR £ GBP $ USD
Licensed Unlicensed Requires Authentication Published by De Gruyter May 4, 2017

DGM News

From the journal International Journal of Materials Research
https://doi.org/10.3139/146.017054
Published Online: 2017-05-04
Published in Print: 2017-05-15

© 2017, Carl Hanser Verlag, München

From the journal
International Journal of Materials Research
International Journal of Materials Research
Volume 108 Issue 5

Journal and Issue

Articles in the same Issue

Contents
Contents
Editorial
Downloads and the impact of Open Access at IJMR
Original Contributions
A material selection approach using the TODIM (TOmada de Decisao Interativa Multicriterio) method and its analysis
Investigation of the influence of Fe on the microstructure and properties of Ti5553 near-β titanium alloy with combinatorial approach
Evolution of the temperature, microstructures and microsegregation in equiaxed solidification of Al-5 wt.% Cu alloy
Phase composition and microstructure of materials in the Ir–Ru–B system prepared by arc melting and VHP sintering
Thermal shock behavior of rare earth modified alumina ceramic composites
Investigation of tribological and corrosion properties of CuTi–alumina nanocomposite fabricated by mechanical alloying
Effect of acetic acid on corrosion behavior of AISI 201, 304 and 430 stainless steels
Verification of strength mis-match of electron beam welded heavy thickness titanium alloy
Short Communications
Effect of toughening Fe2B by the addition of tungsten on the wear resistance of Fe–B–C alloy
Microstructural stability of heat-resistant high-pressure die-cast Mg-4Al-4Ce alloy
DGM News
DGM News
Downloaded on 29.9.2023 from https://www.degruyter.com/document/doi/10.3139/146.017054/html
Scroll to top button