Change language
English Deutsch
Change currency
€ EUR £ GBP $ USD
Licensed Unlicensed Requires Authentication Published by De Gruyter October 4, 2019

DGM News

From the journal International Journal of Materials Research
https://doi.org/10.3139/146.019104
Published Online: 2019-10-04
Published in Print: 2019-10-16

© 2019, Carl Hanser Verlag, München

From the journal
International Journal of Materials Research
International Journal of Materials Research
Volume 110 Issue 10

Journal and Issue

Articles in the same Issue

Review
Status and development of powder metallurgy nickel-based disk superalloys
Original Contributions
Numerical simulation and global heat transfer computations of thermoelastic stress in Cz silicon crystal
Influence of inter-object relations on the microstructural evolution during hot upsetting of a steel billet determined by numerical simulation
Structural and electrochemical properties of lithiated conical carbon nanotubes as anode materials for lithium ion accumulating systems
Effect of nitrogen content on microstructure, mechanical properties, and corrosion behaviour of coarse-grained heat-affected zone of nitrogen-containing austenitic stainless steel
The effect of thermomechanical treatment on the microstructure and mechanical properties of high Mn–Cr austenitic steels
Effect of nanostructured Al on microstructure, microhardness and sliding wear behavior of Al–xGnP composites by powder metallurgy (PM) route
Surface mechanical attrition treatment of commercially pure titanium by electromagnetic vibration
High-temperature oxidation resistance behavior of porous Ni-16Cr-9Al materials
Effect of sintering temperature on structural and magnetic properties of bulk Mg-ferrites
Contents
Contents
DGM News
DGM News
Downloaded on 9.6.2023 from https://www.degruyter.com/document/doi/10.3139/146.019104/html
Scroll to top button