Change language
English Deutsch
Change currency
€ EUR £ GBP $ USD
Publicly Available Published by De Gruyter October 23, 2019

Note from the Editor-in-Chief

  • Eric J. Mittemeijer
From the journal International Journal of Materials Research
https://doi.org/10.3139/146.019111
Download article (PDF)
Published Online: 2019-10-23
Published in Print: 2019-11-12

© 2019, Carl Hanser Verlag, München

Download article (PDF)
From the journal
International Journal of Materials Research
International Journal of Materials Research
Volume 110 Issue 11

Journal and Issue

Articles in the same Issue

Contents
Contents
Editorial
Note from the Editor-in-Chief
Original Contributions
The softening factor cb of commercial titanium alloy wires
A comparative assessment of cyclic deformation behavior of SA333 Gr-6 steel at ambient and elevated temperatures
Effects of Ni and Al on the Cu-precipitation in ferritic Fe–Cu–M (M = Ni or Al) alloy
Effect of manganese on the microstructure and mechanical properties of magnesium alloys
Effect of heat treatment and extrusion on wear properties of AZ91-Pr alloy
Effect of anodization treatment on the mechanical properties and fatigue behavior of AA2017-T4 aluminum alloy Al–Cu–Mg1
Microstructural and tribological characterization of molybdenum–molybdenum carbide structures produced by spark plasma sintering
Investigation of indentation and dry sliding wear behaviour of Al-12.6 wt.% Si-10 wt.% TiB2 composites produced by sequential milling and pressureless sintering
Enthalpies of mixing in ternary Ce–Cu–Sb liquid alloys
Effect of in-situ formation of AlP on solidification of hypereutectic Al–Si alloy
Complex-shaped high speed steel with high mechanical performance fabricated by gelcasting sintering
Internal electromagnetic stirring method for preparing a large-sized aluminum alloy billet
DGM News
DGM News
Downloaded on 28.3.2023 from https://www.degruyter.com/document/doi/10.3139/146.019111/html
Scroll Up Arrow