Accessible Requires Authentication Published by De Gruyter September 7, 2020

Production and properties of functionally graded hybrid composites containing Al3Ti and TiB2

Ömer Savaş

Abstract

This study examined the production and properties of functionally graded hybrid composites containing titanium di-boride (TiB2) and titanium tri-aluminate (Al3Ti) particles. The composites were produced by the centrifugal solid particle method at 850 °C. A detailed study of the microstructures, hardness and abrasive wear behavior of the hybrid composites was carried out. The results showed that the produced composites had three different regions along the centrifugal force direction. It was found that there were Al3Ti particles in the outer region, TiB2 particles in the middle region and neither Al3Ti nor TiB2 particles in the inner region of the functionally graded composites. It was determined that the abrasive wear properties of the composites were improved by 5 times with about 33 wt.% Al3Ti and by 3 times with about 7 wt.% TiB2 in comparison to the pure aluminum matrix.


Correspondence address, Dr. Ömer Savaş, Yildiz Technical University, Faculty of Naval Architecture and Maritime, 34349 Istanbul, Turkey, Tel: +90 2123833002, Fax: +90 2123832940, E–mail:

References

[1] M. Rosso : J. Mater. Process. Technol.175 (2006) 364375. 10.1016/j.jmatprotec.2005.04.038 Search in Google Scholar

[2] R. Singh , V.Bhavar, P.Kattire, S.Thakare, S.Patil, R.K.P.Singh: Mater. Sci. Eng.229 (2017) 09. 10.1088/1757-899X/229/1/012021 Search in Google Scholar

[3] M. Naebe , K.Shirvanimoghaddam: Appl. Mater. Today.5 (2016) 223245. 10.1016/j.apmt.2016.10.001 Search in Google Scholar

[4] T.P.D. Rajan , B.C.Pai: Mater. Sci. Forum.690 (2011) 157161. 10.4028/www.scientific.net/msf.690.157 Search in Google Scholar

[5] S.V. Prasad , R.Asthana: Tribol. Lett.17 (2004) 445453. 10.1023/B:TRIL.0000044492.91991.f3 Search in Google Scholar

[6] S.C. Tjong , Z.Y.Ma: Mater. Sci. Eng., R.29 (2000) 49113. 10.1016/S0927-796X(00)00024-3 Search in Google Scholar

[7] S.L. Pramod , S.R.Bakshi, B.S.Murty: J. Mater. Eng. Perform.24 (2015) 21852207. 10.1007/s11665-015-1424-2 Search in Google Scholar

[8] B.S.S. Daniel , V.S.R.Murthy, G.S.Murty: J. Mater. Process. Technol.68 (1997) 132155. 10.1016/S0924-0136(96)00020-9 Search in Google Scholar

[9] Q. Gao , S.Wu, S., X.Xiong, R.Du, P.An: J. Alloys Compd.692 (2017) 19. 10.1016/j.jallcom.2016.09.013 Search in Google Scholar

[10] K.L. Tee , L.Lu, M.O.Lai: J. Mater. Process. Technol.89–90 (1999) 513519. 10.1016/S0924-0136(99)00038-2 Search in Google Scholar

[11] K.L. Tee , L.Lu, M.O.Lai: Compos. Struct.47 (2000) 589593. 10.1016/S0263-8223(00)00030-1 Search in Google Scholar

[12] K.L. Tee , L.Lu, M.O.Lai: Mater. Sci. Technol.17 (2010) 201206. 10.1179/026708301101509863 Search in Google Scholar

[13] M.O. Lai , Y.Su, H.L.Teo, C.F.Feng: Scr. Mater.45 (2001) 10171023. 10.1016/S1359-6462(01)01128-9 Search in Google Scholar

[14] L. Lu , M.O.Lai, F.L.Chen: Acta Mater.45 (1997) 42974309. 10.1016/S1359-6454(97)00075-X Search in Google Scholar

[15] H. Zhang , J.Geng, X.Li, Z.Chen, M.Wang, N.Ma, H.Wang: Appl. Surf. Sci.422 (2017) 359371. 10.1016/j.apsusc.2017.06.043 Search in Google Scholar

[16] C.S. Ramesh , A.Ahamed, B.H.Channabasappa, R.Keshavamurthy: Mater. Des.31 (2010) 22302236. 10.1016/j.matdes.2009.10.019 Search in Google Scholar

[17] C.S. Ramesh , S.Pramod, R.Keshavamurthy: Mater. Sci. Eng., A.528 (2011) 41254132. 10.1016/j.msea.2011.02.024 Search in Google Scholar

[18] Z. Liu , Q.Han, J.Li: Powder Technol.247 (2013) 5559. 10.1016/j.powtec.2013.07.005 Search in Google Scholar

[19] C. Tijun , L.Jian, H.Yuan: Chin. Foundry.6 (2009) 319327. Search in Google Scholar

[20] X. Wang , A.Jha, R.Brydson: Mater. Sci. Eng., A.364 (2004) 339345. 10.1016/j.msea.2003.08.049 Search in Google Scholar

[21] A. Sreenivasan , S.P.Vizhianb, N.D.Shivakumarc, M.Munirajua, M.Raguramand: Lat. Am. J. Solids Struct.8 (2011) 18. 10.1590/S1679-78252011000100001 Search in Google Scholar

[22] M. Nofar , H.R.Madaah Hosseini, N.Kolagar-Daroonkolaie: Mater. Des.30 (2009) 280286. 10.1016/j.matdes.2008.04.071 Search in Google Scholar

[23] S. Kumar , M.Chakraborty, V. SubramanyaSarma, B.S.Murty: Wear.265 (2008) 134142. 10.1016/j.wear.2007.09.007 Search in Google Scholar

[24] S. Kumar , V.S.Sarma, B.S.Murty: Mater. Sci. Eng., A.465 (2007) 160164. 10.1016/j.msea.2007.02.117 Search in Google Scholar

[25] S. Kumar , V. SubramanyaSarma, B.S.Murty: Metall. Mater. Trans. A.40 (2009) 223231. 10.1007/s11661-008-9696-x Search in Google Scholar

[26] K. Krishnamurthy , M.Ashebre, J.Venkatesh, B.Suresha: J. Mineral. Mater. Charact. Eng.05 (2017) 7489. 10.4236/jmmce.2017.52007 Search in Google Scholar

[27] Y. Watanabe , Q.Zhou, H.Sato, T.Fujii, T.Inamura: Jpn. J. Appl. Phys.56 (2017) 011. 10.7567/JJAP.56.01AG01 Search in Google Scholar

[28] S. El-Hadad , S.E.Hisashi, S.Eri, M.Y.Watanabe: Jpn. J. Appl. Phys.50(1S1):01AJ02. 10.1143/JJAP.50.01AJ02 Search in Google Scholar

[29] M.F. Forster , R.W.Hamilton, R.J.Dashwood, P.D.Lee: Mater. Sci. Technol.19 (2003) 12151219. 10.1179/026708303225005872 Search in Google Scholar

[30] S. Kumar , V. SubramaniyaSarma, B.S.Murty: Phys. Metall. Mater. Sci.41 (2010) 242254. 10.1007/s11661-009-0063-3 Search in Google Scholar

[31] S. El-Hadad , H.Sato, E.Miura-Fujiwara, Y.Watanabe: Materials.3 (2010) 46394656. PMid:28883345; 10.3390/ma3094639 Search in Google Scholar

[32] N. Radhika , R.Raghu: Trans. Indian Inst. Met.71 (2018) 715726. 10.1007/s12666-017-1204-9 Search in Google Scholar

[33] R. Kayikci , Ö.Savaş: J. Compos. Mater.49 (2015) 20292037. 10.1177/0021998314541490 Search in Google Scholar

[34] P. Moldovan , GabrielaPopescu, M.Butu, V.Soare: In-situ Al/TiB 2 composite obtained through reaction in liquid phase, Conference: ICSAAMM 2009, Tarbes, France. Search in Google Scholar

[35] J. Hashim , L.Looney, M.S.J.Hashmi: J. Mater. Process. Technol.123 (2002) 251257. 10.1016/S0924-0136(02)00098-5 Search in Google Scholar

[36] R.G. Guan , D.Tie: Acta Metall. Sinica.30 (2017) 409432. 10.1007/s40195-017-0565-8 Search in Google Scholar

[37] Z. Fan , Y.Wang, Y.Zhang, T.Qin, X.R.Zhou, G.E.Thompson, T.Pennycook, T.Hashimoto: Acta Mater.84 (2015) 292304. 10.1016/j.actamat.2014.10.055 Search in Google Scholar

[38] S. Chatterjee , A.Ghosh, A. BasuMallick: Mater. Today; Proceedings.5 (2018) 1011810130. 10.1016/j.matpr.2017.11.008 Search in Google Scholar

[39] G. Chen , Y.Jin, H.Zhang, F.Han, Q.Chen, J.Xu, Z.Zhao: Mater. Sci. Eng., A.724 (2018) 181188. 10.1016/j.msea.2018.03.089 Search in Google Scholar

[40] R. Gupta , B.S.S.Daniel: Mater. Today: Proceedings.5 (2018) 1693616945. 10.1016/j.matpr.2018.04.097 Search in Google Scholar

[41] K. Ozdin : J. Mater. Process. Technol.183 (2007) 301309. 10.1016/j.jmatprotec.2006.10.021 Search in Google Scholar

Received: 2019-12-30
Accepted: 2020-06-15
Published Online: 2020-09-07
Published in Print: 2020-09-16

© 2020, Carl Hanser Verlag, München