Change language
English Deutsch
Change currency
€ EUR £ GBP $ USD
Licensed Unlicensed Requires Authentication Published by De Gruyter February 20, 2017

Contents

From the journal International Polymer Processing
https://doi.org/10.3139/217.017012
Published Online: 2017-02-20
Published in Print: 2017-03-03

© 2017, Carl Hanser Verlag, Munich

From the journal
International Polymer Processing
International Polymer Processing
Volume 32 Issue 1

Journal and Issue

Articles in the same Issue

Contents
Contents
Editorial
New Associate Editor for the Americas
Regular Contributed Articles
Effect of Flow Induced Orientation of Carbon Nanotubes on the Capillary Extrusion Behavior of Low-Density Polyethylene
Mullins Effect under Compression Mode and its Reversibility of Thermoplastic Vulcanizate Based on Ethylene-Vinyl Acetate Copolymer/Styrene-Butadiene Rubber Blend
Bio-Based Hybrid Polymers from Vinyl Ester Resin and Modified Palm Oil: Synthesis and Characterization
Study on Crystal Form Transition and Non-Isothermal Crystallization of Glycidyl Methacrylate Grafted Isotactic Polybutene-1
Flashing Method for Fabricating Micro Scale Fibers, Spheres, Porous and Condensed Polymer Structures
Preparation and Performance Evaluation of SPEEK/Polyaniline Composite Membrane for Direct Methanol Fuel Cell
Rotational Molding of Linear Low Density Polyethylene (LLDPE) Fumed Silica Nanocomposites
Design Guidelines to Balance the Flow Distribution in Complex Profile Extrusion Dies
Microstructure and Mechanical Properties of Nanocomposite Based on Polypropylene/Ethylene Propylene Diene Monomer/Graphene
An Engineering Model that Simulates Pantographing Occurring in the Shaping Process of Reinforced Uncured Rubber Parts
The Influence of Different Melt Temperatures on the Mechanical Properties of Injection Molded PA-12 and the Post Process Detection by Thermal Analysis
Morphology and Thermal Behavior of TPU/PP Blends Modified with Maleic Anhydride Grafted SEBS-g-MA Block Copolymer
Extrusion Blow Molding of Polymeric Blends Based on Thermotropic Liquid Crystalline Polymer and High Density Polyethylene
Characterization of Stereocomplex Polylactide/Nanoclay Nanocomposites
Attempts to Optimize the Dispersion State during Twin-Screw Extrusion of Polypropylene/Clay Nanocomposites
Rapid Communications
Improved Layer Mechanical Properties of Micro Injection Molded PP
PPS News
PPS News
Seikei Kakou Abstracts
Seikei-Kakou Abstracts
Downloaded on 4.12.2023 from https://www.degruyter.com/document/doi/10.3139/217.017012/html
Scroll to top button