Cellulose – Hemicelluloses – Lignin – Wood Extractives
Editor-in-Chief: Salmén, Lennart
Editorial Board: Daniel, Geoffrey / Militz, Holger / Rosenau, Thomas / Sixta, Herbert / Vuorinen, Tapani / Argyropoulos, Dimitris S. / Balakshin, Yu / Barnett, J. R. / Burgert, Ingo / Rio, Jose C. / Evans, Robert / Evtuguin, Dmitry V. / Frazier, Charles E. / Fukushima, Kazuhiko / Gindl-Altmutter, Wolfgang / Glasser, W. G. / Holmbom, Bjarne / Isogai, Akira / Kadla, John F. / Koch, Gerald / Lachenal, Dominique / Laine, Christiane / Mansfield, Shawn D. / Morrell, J.J. / Niemz, Peter / Potthast, Antje / Ragauskas, Arthur J. / Ralph, John / Rice, Robert W. / Salin, Jarl-Gunnar / Schmitt, Uwe / Schultz, Tor P. / Sipilä, Jussi / Takano, Toshiyuki / Tamminen, Tarja / Theliander, Hans / Welling, Johannes / Willför, Stefan / Yoshihara, Hiroshi
IMPACT FACTOR 2018: 2.579
CiteScore 2018: 2.43
SCImago Journal Rank (SJR) 2018: 0.829
Source Normalized Impact per Paper (SNIP) 2018: 1.082
Oxidative stabilisation of kraft lignin for carbon fibre production
With the aim of investigating kraft lignin as a raw material for carbon fibre production, different lignins have been stabilised in air at conditions varied according to a full factorial experimental design. The lignins under examination were purified kraft lignin powders originating from birch, spruce/pine and Eucalyptus globules, as well as lignin fibres originating from birch with 5% poly(ethylene oxide) (PEO) added as a plasticiser. The influence of temperature, time and heating rate on yield and glass-transition temperature (Tg) was investigated. The highest yield was achieved after stabilisation at 280°C during 2 h with a heating rate of 0.2°C min-1. The Tg of all lignin powders was increased when stabilisation occurred under harsher conditions. X-ray photoelectron spectroscopy analysis (XPS) of both the outer surface and the cleaved cross-section of individual lignin/PEO fibres showed a clear gradient in the degree of chemical modification, with the major change occurring on the surface resulting in the appearance of a skin-core structure after stabilisation. The behaviour of the lignin fibres during stabilisation is similar to that of pitch-based fibres, indicating good possibilities for lignin as raw material for carbon fibre production.
Here you can find all Crossref-listed publications in which this article is cited. If you would like to receive automatic email messages as soon as this article is cited in other publications, simply activate the “Citation Alert” on the top of this page.